Have you ever played arcade game consoles? Generally, arcade game consoles have joysticks. And we are also very familiar with the claw crane machine, almost all of them are joysticks. Most of the rockers are round seats. I will first teach you how to correct the 45-degree angle.
If the angle is not correct, it is not easy to have the problem of oblique up and down. Now it is a rocker with a nut removed. To correct a 45-degree angle, you need a pair of pointed pliers. Pinch the front end of the jog firmly, and bend it inward. The bending angle must be close to the end of the rocker. Only the top end of the jog can be adjusted, and other parts cannot be adjusted. Adjust the angle and put on the back cover to see if it feels sensitive. If it is not sensitive, you can continue to adjust it. Make sure to make small adjustments. The amplitude should not be too large. Otherwise, a micro movement will be abolished. It is best to have a certain amount of margin for the jog, otherwise it will be more difficult to make moves. If the wire falls off, it is best to use an anti-static electric soldering iron to solder the off point. Do not use a static electric soldering iron for soldering, because an electrostatic soldering iron can easily damage the micro-board of the rocker.
The black spots in the micro-board are the integrated blocks, which are professionally called Baba blocks, which cannot be repaired. Each welding place has a dot. Regarding the problem of using lubricating oil (motor oil) and butter in the rocker, it is not possible to add lubricating oil (motor oil) and butter to the rocker. This will increase the adhesion of objects inside the rocker. The internal use of the rocker is heavy and cannot be used. This is because the oil adhesion is too high. Remove the rocker base and wipe off the debris on the micro-movement with toilet paper. Wipe one and install one. Don’t remove it all at once, so as to avoid micro-shifting and reduce the accuracy. If the rocker is not sensitive, you can add some rust removal spray. If the rust removal spray takes a long time, there will be a layer of dirt. Remove and shake. The iron rod of the pole Remove the iron pole and wipe it with toilet paper. Do not use water to avoid rust. You can use rust-removing spray, which must be wiped clean.
The claw crane machine fretting problem can also be repaired. From here, there is carbon deposit on the joint point of opening the fretting, wipe it with a soft object, just wipe off the carbon deposit.
Post time: Aug-27-2021